Location:Home > Parts information > Turbo shaft > Why so much up & down movement?

Why so much up & down movement?

Time:2017-10-19 09:09Turbochargers information Click:

movement much Down

grego37
Gearhead

Posts: 411
From: los angeles,CA,USA
Registered: May 2004 posted 07-27-2005 10:31 AM             Depending upon what aftermarket shaft you're using,on the one Im using, the retaining ring is at the bottom of the top hex (approx 1" from the top) cup side down.
install the shaft from the bottom at the same time you install the oil pump.

The retaining ring keeps the shaft from following the dist. if you were to pull the dist. out.

If your bottom end is allready together and you are just upgrading your shaft, then remove the retaining ring and install from the top.

Copyright infringement? Click Here!